Spirodoc
cod. 980156
Rev 1.3
EN 56/67
E
N
GLI
S
H
WARNING
Do not sterilize by irradiation, steam or by using ethylene oxide.
Unplug the sensor from the device before cleaning or disinfecting it.
5.3
Changing the adhesive wrap sensor
The adhesive tape is made with latex-free material.
Gently remove the used adhesive tape from the sensor and dispose of it.
The back of the sensor has alignment pins. Place the sensor with the alignment
pins facing the adhesive part of the tape and align the pins to the holes on the
tape.
Push the sensor so as to insert the pins into the holes of the tape. Lift both the
sensor and the tape and check that the pins of the sensor are properly aligned.
WARNING
It is highly suggested to use a new piece of adhesive tape for each patient, or as
required.
5.4
Battery charging
Turn on
SPIRODOC
and the following icon will appear on the main screen showing the
charge level of the battery pack:
The maximum charge level is displayed with all 6 bars inside the battery.
If only one bar is shown or if the device will not even turn on the battery pack must be
recharged in the following manner:
Plug the battery charger into a socket and the battery charger cable into the micro
USB connector of the device; the device in this phase is always turned on
When the charging is complete the battery icon will display all six bars.
At this point disconnect the battery charger from the device.
WARNING
It is recommended not to use the device while the battery is charging.
Always disconnect the battery charger from the device when the charge cycle
has terminated.
6. PROBLEM SOLVING
Please find below a list of problems that may arise when using
SPIRODOC.
Diagnostic messages are also shown on the display indicating the type of malfunction:
6.1
Causes and solutions
The
SPIRODOC
will not turn on
