Spirodoc
cod. 980156
Rev 1.3
EN 45/67
E
N
GLI
S
H
WARNING
Before carrying out a test, if the power supply value is low the following
message will appear:
Low battery level
Touch the ESC icon to exit the test, otherwise after a seconds will start the test.
In the event that a test is interrupted due to a complete battery discharge, the
next time the device is turned on the following message is displayed:
WARNING
Wrong interruption of last oximetry test
At the same time an intermittent beep is emitted for ten seconds.
Subsequently the SPIRODOC returns to the main screen.
WARNING
Avoid twisting the sensor’s cable as this may compromise measurement
accuracy and the integrity of the sensor itself, also do not apply excessive force
when using, connecting, disconnecting or storing the oximetry sensor.
The first few seconds are used to find the best signal possible; after which the
SPIRODOC timer resets itself and the device starts recording data.
For any type of oximetry test if the sensor is not properly connected the following
message will be displayed on screen after a few seconds:
WARNING
Sensor not inserted
At the same time
SPIRODOC
emits an acoustic signal for 10 seconds.
If the sensor has been connected properly but the finger has not been properly
inserted in the sensor the following message will be displayed on screen.
WARNING
FINGER not inserted
At the same time
SPIRODOC
emits an acoustic signal for 10 seconds.
If the signal reaches the sensor properly, after a few seconds the device will emit an
acoustic signal while also displaying the values on screen.
At the same time
SPIRODOC
emits an acoustic signal for 10 seconds.
The alarms can be customized for any oximetry test, the procedure is described in
paragraph 3.6.
During oximetry testing if the SpO2 and blood pulse rate fall below the bottom
threshold or raise above the threshold, the
SPIRODOC
will emit a continuous acoustic
signal
„beep‟ until such situation persists. This function can be disabled for sleep
oximetry testing.
