28
3.7.
Operation and Setup Instructions
3.7.1 Startup in the Normal Mode
3.7.1.1 Switch the Utility power circuit breaker (at the service panel) to the On
position.
3.7.1.2 Switch the UPS’s Input circuit breaker (on the rear panel) to the On
position.
3.7.1.3 The UPS will startup. The Green LEDs
&
will illuminate to show
the Utility and Bypass Inputs are normal. The LCD display will display
drawing A then drawing B.
A.
B.
3.7.1.4 The UPS is in Bypass mode. The UPS will automatically perform a self-
test. If there are no error codes displayed then the UPS has successfully
passed the startup self-test and will start charging the batteries.
3.7.1.5 Press and hold the On Switch (on the front panel)
for approximately
3-seconds, then release. The audible alarm will sound 2-beeps then the
LCD display will change from drawing B to drawing C.
C
29
3.7.1.6 The UPS will perform another self-test and the LCD display will change
from drawing C to drawing D. During the self-test the UPS will switch to
the Battery mode for approximately 4-seconds, then the LCD display will
change from drawing D to drawing E1. Once the UPS successfully passes
the self-test the LCD will display drawing F. If the UPS fails the self-test the
LCD will display drawing E2 then the LCD will display an error code or
error status. See Section 2.2 for Error codes and Section 4 for
Troubleshooting.
D
* It shows “test” during the self-test.
E1
* It shows “OK” if the self-test was successful.
E2
* It shows “Fail” if the UPS fails the self-test.
F
* It shows “208VAC” Utility Input.
