Minster IOI, Руководство по обслуживанию

Страница: 12 / 92

!
WARNING
NEVER PLACE HANDS OR ANY OTHER PART OF THE BODY UNDER
THE SLIDE OR WITHIN THE DIE AREA.
OPERATE, SERVICE OR ADJUST THIS PRESS, OR INSTALL
DIES, WITHOUT PROPER INSTRUCTIONS AND WITHOUT FIRST
READING AND UNDERSTANDING THE INSTRUCTIONS IN THE
OPERATION AND/OR SERVICE MANUAL.
INSTALL DIES OR SERVICE THE PRESS WITH THE FLYWHEEL
IN MOTION, MOTOR ON, OR THE SLIDE IN AN UNBLOCKED
POSITION.
NEVER
NEVER
NEVER REMOVE THIS SIGN, THE OPERATION MANUAL, OR THE SER-
VICE MANUAL FROM THE PRESS.
NOTE: IT IS THE EMPLOYER’S RESPONSIBILITY TO ENSURE USAGE
OF ALL GUARDS, SAFETY DEVICES, OR TOOLS THAT MAY BE
NECESSARY AND/OR REQUIRED BY ANY PARTICULAR USE
AND/OR OPERATION TO IMPLEMENT THE ABOVE.
NEVER remove the Operation or Service Manual from press.
PREPARATION FOR USE
NOTE: The press is not ready for production operation until the following conditions have been observed and all
installation work performed in the order listed.
CAREFULLY PERFORM PRESS INSTALLATION PER INSTRUCTIONS
Install the press according to instructions given in the “Installation” section of this manual. Refer to the “Initial Lubrica-
tion” section, being certain to lubricate the press thoroughly. DO NOT set dies or attach any auxiliary equipment until
instructed to do so; however, if the press was received with auxiliary equipment already installed, DO NOT remove.
UNDERSTAND PRESS OPERATING PROCEDURES
Read and understand all information provided in the Model 101 OBI/OBS Series Press “Operation” Manual. Learn
to Inch and Stroke the slide before the dies are installed.
CHECK ALL OPERATING ADJUSTMENTS
Make certain that all operating adjustment procedures have been satisfactorily performed. Learn to properly adjust
(and lock) slide height and know how to adjust the air pressure. Before installing dies, check slide parallelism and
gib adjustment to make certain factory settings were not disturbed during shipment. Readjust only if necessary.
THEN . . .
Set dies. Adjust slide shutheight to the proper setting. Adjust pressure regulators for correct air pressure at clutch,
counterbalance and die cushion if used.
Install auxiliary equipment and adjust or synchronize, as necessary, for proper operation with the press.
Check point-of-operation safeguarding being used for the specific operation being undertaken.
OBSERVE ALL SAFETY PRECAUTIONS
Check the point-of-operation safeguarding and make certain that it is appropriate for the operation being undertak-
en. Refer to the “MINSTER Power Press Safety Manual No. 805” for additional safety related information.
AND DON’T FORGET . . .
It is user-management’s responsibility to make certain that all point-of-operation guards or devices are used,
checked, maintained, and where applicable, adjusted on every operation performed on a production system for
every individual exposed to a point-of-operation hazard.
B - 3
Manual Pocket
Electrical Control
Pedestal