Minolta MAGICOLOR 3300, Руководство пользователя

Страница: 84 / 194

Cleaning the Printer 76
When does the printer need cleaning?
What cleaning materials should I use?
Attention
Do not vacuum the printer; vacuuming could cause static electricity to
build up and damage sensors.
Make sure any parts removed during cleaning are replaced before you plug in
the printer.
20,480–25,599 20
25,600–30,720+ 16
Note: The cleaning cycle interval is more frequent as the imaging unit ages.
This item needs cleaning... After... By...
Printer exterior Every month, or as
necessary User
Density sensor
ADC SENSOR DUSTINESS
WARNING
appears in the mes-
sage window
.
Use Avoid
Exterior
A soft dry cloth to clean the
control panel. Sharp or rough implements (such as
wire or plastic cleaning pads); any liquid.
A soft damp cloth to clean the out-
side of the printer. Sharp or rough implements (such as
wire or plastic cleaning pads).
Mild neutral detergent to clean the
outside of the printer if stains
remain. (Always test any cleaning
solution on a small area of your
printer to check the solution's
performance). Abrasive or corrosive solutions that
contain solvents (such as alcohol or
benzine); aerosol or pump-sprayed
cleaners.
Interior
A soft dry cloth or cotton swab to
clean the density sensor. Vacuuming.
Pulling media too hard and tearing it.
Sharp implements (such as tweezers)
Image Unit Print Count Printer Pauses Every x Simplex Pages