Minolta MAGICOLOR 3300, Руководство пользователя

Страница: 110 / 194

Solving Problems 102
Printer takes
too long to start
when you are
replacing the
imaging unit. The printer takes
approximately 6
minutes to warm up
when a new imaging
unit is installed. Wait. No action needed.
Printer stops
and displays
one of the
following
messages:
INVALID ID
FUSER UNIT
INVALID ID
IMAGING
UNIT
INVALID ID
TONER
CARTRIDGE
The printer has
detected a
nongenuine
MINOLTA-QMS
consumable: fuser
unit, imaging unit, or
toner cartridge. To resume printing and to prevent
permanent damage to your MINOLTA-QMS
printer, replace the consumable with a
genuine MINOLTA-QMS consumable. If
you are already using a genuine
MINOLTA-QMS consumable and still
receive this error, contact Support. Refer to
the Service & Support Guide or
www.minolta-qms.com/support.
Not all pages
print. The printer has the
wrong kind of cable,
or the printer is not
configured for the
correct cable and
port. Check your cable.
The Cancel key was
pressed. Make sure no one pressed the Cancel key
while your job was printing.
The media tray is
empty. Check the message window to see if the
tray you are using is out of media.
Printer resets
or turns off
frequently. The power cord is
not properly
connected to the AC
outlet. Turn off the unit, confirm that the power
cord is properly connected to the AC outlet,
and turn the unit back on.
A system error
occurred. Contact Technical Support with the error
information. Refer to the Service & Support
Guide or www.minolta-qms.com/support.
Symptom Cause Solution