Minolta MAGICOLOR 2, Руководство пользователя

Страница: 52 / 188

Introduction
QMS magicolor 2 Op eration 5-2
Introduction
This chapter describes how to handle and clean the printer.
Blurred or splotchy prints and paper jams can result from dusty printer
parts. Regular cleaning takes only a few minutes and helps ensure
print quality. Printer parts that require cleaning are the paper pick-up
rollers and the outside surface of the printer.
Handling the Printer
Handle the printer with care to preserve its life. Abuse may cause
damage. Keep the following guidelines in mind:
n
Do not place anything on the top of the printer.
n
Avoid spraying cleaning solution directly on the printer’s surface;
the spray could penetrate through the air vents of the printer and
damage the internal circuits.
n
Be careful when cleaning the inside or removing paper jams, as
the fuser assembly and other internal parts become very hot.
Open the printer cover, and let the interior of the printer cool
before handling the inside of the printer.
n
Always close the printer covers gently. Never expose the printer
to vibrations.
n
Do not cover the printer immediately after using it. Turn it off and
wait until it cools down.
n
Do not leave the printer open for any length of time, especially in
well-lit places; light may damage the OPC belt cartridge.
n
Do not open the printer during printing and do not tap paper
stacks on the printer.
n
Do not tilt, lubricate, or disassemble the printer.