Minicom IP Control, Руководство пользователя

Страница: 58 / 63

Troubleshooting – Safe Mode
Restoring Factory Defaults
56
| IP Control
To enter Safe mode:
1. While powering up IP Control, press and hold down the
back panel of the unit for
The device boots up in Sa
2. Wait until the unit finishes booting (
3. Determine the IP address of the IP Control
whether or not there is a DHCP server on the network. If there is, the DHCP server
assigns an IP address to the IP Control
boots with the static IP address 192.168.2.155.
4. Open Internet Explorer and type into the Address box:
(Do not start the address with
The Login page appears.
5. In
User
, type username
admin
(This username and pass
A menu appears.
While powering up IP Control, press and hold down the
Go Local
button on the
for three to four seconds.
afe mode.
the unit finishes booting (one to two minutes).
the IP address of the IP Control unit. The IP address depends on
there is a DHCP server on the network. If there is, the DHCP server
an IP address to the IP Control unit. If there is no DHCP server, the unit
boots with the static IP address 192.168.2.155.
Open Internet Explorer and type into the Address box:
http://IP address/config
(Do not start the address with
https.
)
Figure 48 – Login Page
admin
, and in
Password
, type
SAFEmode
(case
sword works only in Safe mode.)
Figure 49 – Safe Mode Menu
button on the
. The IP address depends on
there is a DHCP server on the network. If there is, the DHCP server
. If there is no DHCP server, the unit
address/config .
se sensitive).