Mini Pro Slot Car Dyno, Инструкция по эксплуатации

Страница: 9 / 21

8
1. (+) Battery Conn. (Red)
2. (+) Battery Conn. (Red)
3. Electronic Board Conn. - Current
4. Electronic Board Conn. - Voltage
5. Electronic Board Conn. - Ground
6. (+) ESC Conn. (Red)
7. (-) ESC Conn. (Black)
ELECTRONIC CONNECTIONS
Connect Sensor to Electronic Board
2
Voltage and Current Sensor Diagram
Soldering the Sensor
1
7
6
2
5
4
3
1
5
4
3
Voltage and Current
Board Diagram
MINIPRO H1 Voltage and Current Sensor Connection
1
2
3
1.1. Solder the H 1 Sensor using the diagram above.
1.2. Connect the ESC to a battery or power supply (5-V to 12V Max) and turn-on the ESC. An LED should be on. If an
LED is not on, then please check your soldering connection between the H1 Sensor and the ESC.
1.3. Turn Off ESC and disconnect the power source from the H1 Sensor
( + ) Battery/Power Supply
( - ) Battery/Power Supply
( - ) Battery
Side for ESC
( + ) Battery
Side for ESC
( - ) Brushed Motor
( + ) Brushed Motor
5
4
3
IMPORTANT: You must calibrate the sensor each time the
dyno is powered.
Calibration Instructions:
2.1. Open the MINIPRO for Windows application and connect
the dyno to the application.
2.2. Connect the power source to the sensor and make sure
the ESC is turned off.
2.3. Push the reset button from the back of your dyno; and
the current should read zero or close to zero.
2.4. Power your ESC and you should be ready to start your
testing.
1
2
3