7
Install the Flywheel Unit
Install the Slot Car and Start Testing!
4
5
Install the Electronic Speed Control (ESC)
3
The dyno its already been pre-assembled. All you need to do is install the flywheel unit, base plate, sliding block,
slot holder and electronics.
Screw on the Slot Car Holder and Slid-
ing Block to the Base
Screw on the Sensors
ASSEMBLE THE DYNO
1
2
(2) Flat Head Screw
Nylon Flange Nut
Thumbscrew
and Washer
Voltage & Current Sensor (Sold
Seperately)
Note: Picture might be different
from your kit.
Throttle Sensor with
(2) Head Cap Screws
3.1. Make sure the orientation
of the ESC matches this diagram
(Push Buton is outboard) and use
the provided double sided tape
to fix ESC on the base once you
finish with the soldering.
3. 3. Voltage & Current Sensor (Sold Seperate-
ly). See Page 8 for Voltage & Current Sensor
Installation
(+) Red
(-) Black
O
utboar
d
3.2. Connect the ESC to the Throttle
Controller Sensor.
Reference Installation Pictures
NOTE:
Please review Electronic Connection Pages for more information
(4) Flat Head Screw
Velcro Strap
Содержание Slot Car Dyno
