Page 18 of 50
AN-49-003 Rev.: E (September 6, 2019) M175867 (R95153) File: AN49003.doc
This document and its contents are the property of Mini-Circuits
3.1.4
If USB control, or DC power are
not properly connected when you start the program or
are interrupted during operation, a pop-up window will appear advising you to check power and USB
connections. Clicking on ‘Retry’ after the problem has been resolved will cause the pop-up to disappear,
allowing you to operate the generator
. Clicking ‘Cancel’ will cause the program to shut down.
Figure 3.1.4:
Interrupted Power error
3.1.5
The Ethernet configuration
can
only be accessed from the USB control main screen
Click on the Ethernet-Config button shown in the figure below and the Ethernet configuration screen will
appear.
Figure 3.1.5:
Ethernet Config button
3.1.6
The Ethernet Configuration
screen will
open showing the current configuration.
Fig
is showing the factory default of the generators. If these settings fit your local network, you do not
need to access the setup before connecting the generator to the network.
Figure 3.1.6:
Ethernet Config. screen (showing factory default state)
Note:
If you are using a proxy server for your LAN connections you may need to define a name for the
generator IP address, or disable the proxy server to connect to the generator via Ethernet.
3.1.7
The Ethernet Configuration
Settings are:
8
4
2
6
11
3
5
7
9
10
12
1
