Page 12 of 50
AN-49-003 Rev.: E (September 6, 2019) M175867 (R95153) File: AN49003.doc
This document and its contents are the property of Mini-Circuits
2
Chapter 2
– Installation and Setup
This chapter provides information on installing the operating software and setting up Mini-
Circuits’
Generators. System requirements for USB control are a computer (Pentium II or better) with support for
USB HID and a power source of 110-220V (a power cord matching the required power supply should be
selected when ordering the SSG unit).
For Ethernet control an Ethernet port with support for HTTP or Telnet, and a suitable power source are
needed.
To run the GUI program (described in chapter 3) a Windows operating system (either 32 or 64 bits) is also
needed.
2.1
Software Setup
If you have had any problems installing the software, we’re here to help.
Try following these complete step-by-step instructions. If you still experience problems,
give us a call at Mini-Circuits Worldwide Technical support
. It’s (718) 934-4500, or e-mail
[email protected] for North America, or go to minicircuits.com/contact/worldwide_
tech_support.html for other regional numbers and addresses
.
2.1.1
First,
save all work in progress and close any other programs that may be running.
2.1.2
Next,
download the full CD software from minicircuits.com. Unzip the downloaded files to a
temporary folder on your desktop or C: drive, then open the file folder you created and double-click the
“Install” icon.
Figure 2.1.2
CD file listing window
