MiNGARDi Micro One 230, Инструкция по использованию и установке

Страница: 15 / 17

GB
INSTRUCTIONS ON FITTING, USING AND
MAINTAINING THE ACTUATOR
Micro One
D
STROKE ADJUSTMENT
Warning!
The actuator is adjusted to a 300-mm
stroke. Refer to the user’s and
installation manual for setting the
desired stroke.
D01
Power up the actuator and make the entire chain
come out (400-mm stroke). Now position the
adjustable stroke magnet code X00394/068 on the
desired pin (see the stroke table given below) while
keeping the coloured side “in view”. Non-
observance of this rule results in the actuator stroke
remaining unchanged, staying at 400 mm.
Legend of figure D01:
A. Magnet placement side
B. Pin
no. 1
C. Pin no. 2
D. Adjustable stroke magnet
E. Centre
the magnet on the pin while keeping
the coloured side “in view”
Pin no. Stroke Pin no. Stroke
No magnet 400 19 150
31 300 18 138
30 288 17 125
29 275 16 113
28 263 15 100
27 250 14 88
26 238 13 75
25 225 12 63
24 213 11 50
23 200 10 38
22 188 9 25
21 175 8 13
20 163
D02
Power up the actuator and make the entire chain
go back in. Power up the actuator and make the
chain come out until the limit switch trips. Check
that the resulting stroke is the one you want (the
actuator stroke does not comprise the protrusion of
the chain head). If the stroke is not the one you
want, continue with the instructions given in D03.
D03
Power up the actuator to make the whole chain
come out.
24 V DC Version:
•
Disconnect the actuator
•
Position the release key code
CD20303100 on the reference
•
Power up the actuator again
230 V AC Version:
Position the release key code X00394/057 in the
relevant imprint on the side of the actuator until the
stroke starts.
Important!
Immediately remove the release key as
soon as the actuator stroke starts.
Warning!
Forgetting to do so may cause damage
to the actuator.
Legend of figure D03:
A. Adjustable stroke magnet
B. Release key