How to open Battery Compartment Cover
Motorized/Smart Zebra Shades
Instruction Manual
P1
BINTRONIC ENTERPRISE CO., LTD
No.62, Bengong 5th Rd., Gangshan Dist., Kaohsiung City 82059, Taiwan (R.O.C.)
Email: [email protected]
This instruction manual version is v1.0.
All Rights Reserved.
Copyright © 2022 Bintronic Enterprise
1-1 Setting or modifying position of Upper-Limit
1-2 Setting or modifying position of Lower-Limit
1-3 Setting of Light Filtering Position
1-4 Setting of Auto Light Filtering
2-1 Adding another Remote Control Unit
3-1 Alter direction of Zebra Shade movement
4-1 Clear off Password
5-1 Externally connected Manual Switch Box
6-1 Battery Replacement
6-2 Product Specifications
6-3 Quick Setting Index
6-4 Instructions for using Remote Control Holder
UP
STOP
RIGHTWARD
LIGHT FILTERING
UPWARD
LIGHT FILTERING
DOWN
Push the cover out
Insert latches into
corresponding slots
Place Battery
Compartment Cover
to engage it with Slides
1
2
3
Insert latches
How to replace Battery Compartment Cover
Push the cover in
making settings
Key check-points prior to
When setting Upper-/Lower-Limit points,
set Upper-Limit first, then the Lower-Limit.
STEP-1
1
2
1-1 Setting or modifying position of Upper-Limit
STEP-1
First, make sure if the direction of movement is correct. Verify if the Zebra Shade moves upwards
by pressing [UP] and downwards by pressing [DOWN]. After that, carry out setting or modification
of Upper-/Lower-Limit points. In case the Zebra Shade moves in the opposite direction, refer to
the Steps of Item 3-1 in Table of Contents to correct the direction.
Press [SET] + [UP] keys until the Motor
makes a twitch, indicating the setting mode
of Upper-Limit is activated.
STEP-1
STEP-2
Press [UP] or [DOWN] key to move the Zebra Shade to a pre-determined position,
to be set as the Upper-Limit.
back
the Motor will make a twitch
When the Motor makes a
twitch, the Zebra Shade will
move upwards and
downwards at the same time
as a response.
While the Shade is getting close to reaching
the Upper-Limit, please press [STOP] to stop
the movement to avoid damage to the motor.
Then, tap to fine tune to the place where you
would like it to be set up as the Upper-Limit.
press [STOP] and tap
to fine tune to the
Upper-Limit
Tap to fine tune. Press for 2 seconds,
and it will move continuously.
CAUTION
