MIMAKI UJV500-160, Руководство по эксплуатации

Страница: 87 / 228

3-11
1
1
3
Convenient use
5
6
Setting UV mode
If you want to print using the UV lamp light control set
in this machine
1
Press the key in LOCAL.
2
Press the key.
3
Press to select [UV MODE].
4
Press the key.
5
Press to select [CONTROL].
6
Press the key.
7
Press to select the control method.
• If you selected “FULL”
LED UV Lamp : Printing is performed with the LED outside the print range lit up when the print begins
and ends.
Post cure lamp : Printing is performed with this lit from the start of the print.
• If you selected “PRINT”
LED UV Lamp : Printing is performed with the LED outside the print range lit up when the print begins
and ends.
Post cure lamp : It is off at the start of the print, but lights up when the printed object enters the post cure
lamp section.
8
Press the key.
• If you selected “FULL” in Step 7, proceed to Step 12.
9
Press to input the LED UV lamp 1 (left side)
scale position.
Set Value : 0 to 180mm (The LED UV lamp’s normal position is “0mm”.)
10
Press the key.
FUNCT I ON
SE TUP
[ ENT ]
SE TUP
F EED COMP .
[ ENT ]
SE TUP
UV MODE
[ ENT ]
UV MODE
: PA T T ERN
UV MODE
: CONTROL
UV MODE
UV CTR L AREA : FU L L
UV MODE
UV 1 L AMP POS :
0mm
UV MODE
UV 1 L AMP POS :
0mm
UV MODE
UV 2 L AMP POS :
0mm