MIMAKI JV3-130 SP II, Руководство по эксплуатации

Страница: 97 / 144

- 5.9 -
When media thickness is changed [PRINT ADJUST]
When the media thickness, head height, ink type is changed, the dot position is subtly different. This
function corrects the dot positions to ensure that the accurate plotting result is obtained.
The dot positions are corrected by comparing the ink dropping positions on each of the seven test
patterns between the two plotting directions.
• When in use of the roll media, the back side of roll media will loosen after
executing print adjust, for the media returns to the plot original point.
STEP
1. Select the [PRINT ADJUST].
2. Press the [ENTER] key.
Plotting of the test patterns for the correction of dot position
starts. There are seven types of test patterns that are plotted.
3. Press the JOG keys [ ] and [ ] to correct the
dot position of pattern 1.
The seven test patterns that are output are sequentially
named [PATTERN 1] to [PATTERN 7].
Select the correct dot positions on [PATTERN 1] using the
JOG keys [ ] and [ ].
Select the dot positions that make a straight line on the test
pattern in the two plotting directions.
• If the pattern correction value for straight lines is
not within -40 t40, adjust the head height
and then correct it again with [PRINTADJUST].
4. Press the [ENTER] key.
MAINTENANCE
PRINTadjust
< ent >
MAINTENANCE
PRINT START
: ent
MAINTENANCE
PATTERN 1
= 0. 0
Out put direction
Select the dot positions 4.0 that
make a straight line on the test
pattern in two plotting direction.