MIMAKI JV3-130 SP II, Руководство по эксплуатации

Страница: 44 / 144

- 2.10 -
Setting roll media on the device
The procedure for setting roll media on the device is described below.
• The roll media is heavy in weight. Take care not to drop it on your foot.
1. Pull up the clamp lever at the back of the de-
vice.
When the roll holder is attached at the top or bottom position,
it is necessary to use the lock pin.
page 2.14
2. Loosen the screw of the left-hand roll holder.
3. Determine the position of the roll holder.
The inside diameter of the roll media core may be 2 inches or
3 inches.
A roll holder is tighten with screws along the sticker [Roll
holder set].
4. Insert the let-hand roll holder into the core of
the roll media.
Push roll media onto the roll holder till the roll core no longer
moves.
5. Loosen the screw of the right-hand roll holder.
Adjust the roll holder position to the width of the roll media.
• By placing the roll media on the media support
bar, the position of roll holder can be adjusted
easily.