MIMAKI JF-1610, Руководство по эксплуатации

Страница: 14 / 142

xiii
Precautions for use
WARNING
Handling the Anti-freezing liquid
• Use the exclusive Anti-freezing liquid by
Mimaki ,or the heater may be damaged.
• If the Anti-freezing liquid or mixed soft
water with anti-freezing liquid gets on the
skin or clothes, immediately wash it off with
soap.
If you get the Anti-freezing liquid or mixed
soft water with anti-freezing liquid in your
eyes, immediately wash your eyes with a
lot of clean water.
Then, consult a doctor as soon as
possible.If high temperature Anti-freezing
liquid or mixed soft water with anti-freezing
liquid gets on the skin, immediately wash it
off with soap and cool with iced water.
Then, consult a doctor as soon as possible.
• Before using the Anti-freezing liquid, be
sure to read the Material Safety Data Sheet
(MSDS).
• If you swallowed the Anti-freezing liquid or
mixed soft water with antifreezing liquid
accidentally, try to get to vomit, and then
consult a doctor as soon as possible.
• When unused the Anti-freezing liquid or
used mixed soft water with anti-freezing
liquid should discard as followings,
• Incinerating the fluid which is absorbed
to the sawdust or waste cloth.
• Entrust them to an industrial waste
disposal contractor, clarifying their
contents.
• Avoid ignition such as static electricity and
impact spark.
• Be sure to wear goggles and gloves for
handling the Anti-freezing liquid.
CAUTION
Protection against dust Periodic exchange parts
• It is strongly recommended to use the
device in a room that is not dusty.
Set the Refresh level 2 or 3 when in bad
environment.
• When leaving the workshop after the
working hours, be sure to take off any
media from the roll hanger.If any media is
left on the roll hanger, dust can put on it.
• Store media in a bag.Wiping off dust
accumulated on a media will adversely
affect the media due to static electricity.
• Frequently the capping station clean to
eliminate dust and paper chips.
• Dust in the head will also cause drops of
ink to fall abruptly down on the media
during printing.If this phenomenon takes
place, be sure to clean up the head.
(
P.2-10)
• There are some parts which must be
replaced by service men.You have to make
a contract with distributors or dealers for
after-sale service.
Adjusting the level
• The level must be adjusted before printing
can start.
Handling of maintenance liquid
• Be sure to store the maintenance liquid in a
cold and dark place.Store the maintenance
liquid in a place that is out of the reach of
children.