MIMAKI JF-1610, Руководство по эксплуатации

Страница: 120 / 142

5-6
Error message Cause Corrective measure
The X motor has been overload.
• Turn off the power to the device an
turn it on after a while.
• If the same error message appears
again on the LCD, contact your local
distributor to call for service.
The Y motor has been overload.
Overcurrent error on the X motor
has been detected.
Overcurrent error on the Y motor
has been detected.
Y origin could not be detected.
Head temperature is abnormal
condition.
X origin could not be detected.
Z origin could not be detected.
Top end in the Z-axis can not be
detected
The amount of ink remaining in
the ink cartridge is insufficient.
• Replace an ink cartridge of the
displayed head ahead of time.
(
P.4-4)
The ink cartridge has run out of
ink.
• Replace the ink cartridge of which
color is shown on the LCD with a new
one.
( P.4-4)
The ink cartridge is not attached
to the ink station.
• Attach the ink cartridge(s) correspond-
ing with the color shown on the dis-
play.
( P.4-20)
Waste ink tank is full.
• Remove the waste ink tank and set an
empty waste ink tank. ( P.4-22)
Wiping times exceeds the
predetermined value.
• Contact your local distributor to call for
service.
The IC chip of the ink cartridge
cannot be read normally.
• Remove an ink cartridge of the
displayed head and insert it again. If
the error is still displayed after this
operation, call the dealer or our
branch for the service.
E R R O R 4 0 1
MO T O R X
E R R O R 4 0 2
MO T O R Y
E R R O R 4 0 3
X
C U R R E N T
E R R O R 4 0 4
Y
C U R R E N T
E R R O R 5 0 A
Y O R I G I N
E R R O R 5 0 E
H E A D T E M P : 1 2 3 4 5 6 7 8
E R R O R 5 1 0
X O R I G I N
E R R O R 5 1 1
Z
O R I G I N
E R R O R 5 1 1
Z
S N S WO R K
E R R O R 6 0 1
I N K N E A R E N D : MC Y K K CMY
E R R O R 6 0 2
I N K E N D : MC Y K K CMY
E R R O R 6 0 3
N O C A R T R I D G E
E R R O R 6 0 4
! WS I N K T A N K F U L L
E R R O R 6 0 5
! R E P L A C E W I P E R
E R R O R 6 0 6
WR ON G C A R T R I D G E