![background image](http://html1.mh-extra.com/html/milwaukee/48-22-8510-series/48-22-8510-series_operators-manual_1798748007.webp)
7
0DLQWDLQLQJWKH&KHVW&DELQHW
Keep your chest/cabinet in good repair by adopting
a regular maintenance program. Before use, ex-
amine the general condition of your chest/cabinet.
Check for loose screws, misalignment, binding of
wheels, broken parts and any other condition that
may affect its safe operation. Do not use a dam-
aged chest/cabinet.
Maintaining the Casters
Grease the casters annually using high quality
bearing grease.
Warning
7RUHGXFHWKHULVNRILQMXU\
contact
milWaukee
&RUSRUDWH$IWHU 6DOHV
6HUYLFH7HFKQLFDO6XSSRUWIRU$//UHSDLUVDQG
UHSODFHPHQWSDUWV
mainTenance
Maintaining the Drawers
1. Periodically clean the drawer trim, and inside the
drawers with a mild detergent and water.
2. Remove grease and oil in drawer with a standard,
QRQÀDPPDEOHFOHDQLQJÀXLG
3. The use of drawer liners is recommended to
SURWHFWWKH¿QLVKLQVLGHWKHGUDZHUVDQGPDNH
the drawers easier to clean. Drawer liners can
be cleaned with soap and water.
4. Lubricate the slides semi-annually with general
purpose grease or equivalent.
Installing the Drawers
1. Pull the slides and slide carrier out until fully
extended.
2. Hold the slide on the cabinet while aligning it with
the slide on the drawer.
3. Slightly insert one side and repeat for the other
side.
4. Slowly push the drawer until it is fully closed to
engage the slide.
5. Open and close the drawer to verify proper
operation.
Grease
Points
Grease
Points
Mounting Chargers
The rolling cabinet comes equipped with four pre-
installed charger mounting bolts, located below the
power strip. The mounting bolts are suitable for
holding
MILWAUKEE
M18™ & M12™ Multi Voltage
chargers as well as M18™ chargers.
Removing the Drawers
1. Fully extend and empty the drawer.
2. Depending on the side, either lift or lower the
release lever on both sides so the slides can ride
over the stops. Pull out to remove.
Release Lever