Miller DYNASTY 350, Руководство пользователя

Страница: 100 / 136

OM 216 896 Page 94
B. DC - GTAW 16 Gauge Mild Steel* And Stainless Steel Setup
This symbol indicates which functions should be active for stainless or mild steel welding.
Some of the controls shown above may not be on your machine (Dynasty 350/700 illustrated).
 Turn power on (switch located on rear panel)

Press Polarity switch pad until DC LED is lit (Dynasty Models Only)

Press Process switch pad until TIG HF Impulse LED is lit

Press Output switch pad until RMT STD LED is lit

Press Adjust switch pad until Post Flow LED is lit

Turn Encoder control to set 8 seconds of Post Flow time

Press Amperage A switch pad until LED is lit

Turn Encoder control to set desired amperage (50 - 80 amps for stainless steel) or (55 to 88 amps for mild steel*).

Pulser Controls (if applicable, see Section 5-10)
.
The ammeter displays the parameter for any of the following units of measure when they are active: amperage, time, percentage,
or frequency. The corresponding LED, located directly below the ammeter, will also light up. The ammeter also displays actual
amperage while welding.
226 868-B