Miller 907525, Руководство пользователя

Страница: 36 / 56

.
A complete Parts List is available at www.MillerWelds.com
OM-257220 Page 30
7-3. Lift-Arc TIG Welding Mode - GTAW Process
!
Weld terminals are energized
through the remote control in TIG
welding mode.
1 Mode Switch
2 Left Display
3 Right Display
4 Adjust Control
5 Workpiece
6 Tungsten Electrode
Setup
For typical system connections refer to
Section 7-1.
Rotate Mode Switch to LIFT-ARC TIG posi-
tion as shown.
Preset amperage is shown in the Right Dis-
play.
Normal open-circuit voltage is not present
before the electrode touches the work-
piece, instead a low sensing voltage is
present. The sensing voltage allows the
electrode to touch the workpiece without
overheating, sticking, or getting contami-
nated.
Operation
The Adjust Control is used to set desired
preset amperage.
A remote control is required to turn on the
weld output.
To start welding, momentarily depress out-
put switch. Touch tungsten electrode to
workpiece at weld start point. Slowly lift
electrode. An arc will form when electrode
is lifted. If welding arc is not established
within 3 seconds, output will turn off. To stop
welding, momentarily depress output
switch and output will shut off.
.
If a remote control is used for amper-
age adjustment, the adjustment will
function as a percentage of the preset
amperage.
.
For best results, firmly touch the tung-
sten electrode to the workpiece at the
weld start point. Hold electrode to
workpiece for 1-2 seconds, and lift
electrode. An arc will form when the
electrode is lifted. To minimize arc flare
at the end of the weld, pull back the
electrode quickly to extinguish the arc.
256 366-A
1 − 2
Seconds
“Touch”
Do NOT Strike Like A Match!
6
5
2
3
1
4
85