Milkotronic LACTOSCAN SA, Руководство по эксплуатации

Страница: 65 / 110

Ultrasonic milk analyser
Operation manual 11.04.19 65/110
The operator has to place the sample holder filled with milk sample in the milk
analyser and to start the measurement. The milk analyser measures the
sample and shows the results as in a normal mode. On the print out 2 new
lines appear:
Litres………..19.4
Kilograms…..20.00
Please, have in mind the formula for calculating liters from weight measured:
Litres = Kilograms / Density
where:
Density is measured by the analyser density of the correspondent sample.
When the next deliverer arrives, the operator has to press “#” and to start
again the procedure for entering deliverer’s number and weighting. In this
case weighting scales are ready for the next deliverer’s milk. This procedure
is repeated for every deliverer. When the milk-collecting vessel is full, pour its
content in the cooling tank. Place it back on the scales and press again the
button for new tare calculation.
9.7.3. Control options when working with scales.
They are entered by using the Setup of the analyser. They are started using
the following menu:
Setup ->Accessories->Weigh Scale:
Raw Test - test for weight scales control. Used mainly in production
conditions.
Calibration – serves for scales calibration (if there is deviation noticed).
For the purpose you have to have 2 standards of weight, for example 5 and
50 kg.
After starting the following is dispalyed:
Weight Scale Cal
Put Low Weight
Weight =zz.z
Using the buttons Up, Down, Enter (as it is done when calibrating the rest of
the milk analyser’s options) enter the weight of the lighter standard of weight,
in our case 05.000. After it, on the bottom line of the display appers:
ADC=xxxx.x Set