DA-700 CONTROL PANEL/RECEIVER:
1. Weight:
2.2 pounds with antenna attached
2. Dimensions:
5.5” H x 6.0”L x 2.0”D
3. Operating Temp Range:
a low of 0 degrees F, up to a high of 105 degrees F
4. Input Power Supply:
UL Listed 120VAC/208 50/60HZ
5. Power Output:
24VDC at 500MA, 5% Reg, Overload Protection
6. Receiver Power Required: Minimum of 150MA, Maximum 225MA
7. Frequency:
433.92 MZ
8. Antenna:
1/4 Wave Monopole, extendable
9. Receiver/Decoder:
Linx Module KH3
10. Addressable Receiver:
Jumper Select (3 positions)
11. LED Indicators:
RL1 - RL5, Power, Mute, Low Battery
12. Onboard Power Supplies: +3.0VDC, 3.6VDC, 12VDC and 24VDC
13. Inernal Fuse:
F1 solid state device, non user replaceable, automatic reset
14. Onboard Microprocessor: Generate chime tones, control logic and output interface
15. 2 Programmable Timers:
Controlled by microprocessor. Mute Timer silences the chime alert(s) for a programmed period of time of 10, 20, 30 or 60 min.
Utility Timer for accessories, such as lights, with programmable times of 1.5 seconds or 5, 30 and 60 min.
Both timers have relay outputs active for the programmed time period.
16. Relay and Logic Outputs;
All functions have relay and logic outputs via TB1, 20 terminals, to interface all devices, ie security systems or automation systems
17. TB1 Terminal Strip;
Pr24VDC and +12VDC for optional accessories with relay control
18. Manual Select Tone Control Jumper JP3 for single area control mode
DA-610TO Sensor/Transmitter:
1.
Power Requirements:
Two (2) AA Batteries 3.0 VOLTS DC - Lithium Recommended
2.
Operating Frequency:
433.92 MHZ Fixed
3.
Antenna:
6.5” Wire inside outdoor rated transmitter box
4.
Transmitter Output:
2 Milliwatts
5.
Transmitter:
Linx Technologies Model KH Encoder/Transmitter
6.
Encoder Modulation:
Amplitude ON-OFF Keying (OOK) at 1200 BPS.
7.
Address Codes:
Jumper Plugs elected for the encoder (3 positions)
8.
Data:
One Data BIT encoded when battery is low
9.
Transmitter ON time:
Less than 5 seconds for any single alarm
10.
Enclosure:
Outdoor, NEMA 4X, Non-Metallic, Weather Sealed enclosure houses the Transmitter
11.
Quiescent Current :
60 Microamp
12.
Active Current:
3 Milliamp
13.
Battery Life:
One Year in residential installation, but up to 5 years if using lithium batteries
14.
Operating Temperature:
-40 DEGREES F TO + 125 DEGREES F
15.
Weight:
3 Pounds
16.
Detection of Vehicles:
Distance from Sensor/Transmitter for a standard sedan moving at 5mph+ is 14 feet max, 9 feet min, 7 feet, min
DA-611TO Sensor/Transmitter:
ALL SPECIFICATIONS ARE THE SAME AS THOSE LISTED FOR THE DA-610TO ABOVE, EXCEPT THE FOLLOWING:
A.
The sensor is not inside the transmitter enclosure; it is an external sensor attached to the transmitter enclosure with 50’ of cable (see sensor options page)
B.
Detection of Vehicles:
Distance from Sensor for a standard sedan moving at 5mph+ is 17 feet max, 12 feet min, 10 feet min
FCC ID: SGXMPIDA066
This device complies with Part 15 of the FCC Rules and Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:
(1) This device may not cause harmful interference
(2) This device must accept any interference received, including interference that may cause undesired operation.
Any changes not expressly authorized by Mier Products, Inc. may void the user’s authority to operate this equipment.
IC ID: 5583ADA-066MP
Cet appareil est conforme a des reglements d’industrie Canada exempts de license standard RSS (s). Son fonctionnement est soumis aux deux conditions:
(1) Ce dispositif ne doit pas causer d’interferences nuisibles
(2) Cel appareil doit accepter toute interference recue, y compris les interferences pouvant entrainer un functionnement indesirable.
DA-066MP Wireless Chime Transmitter (optional accessory):
The DA-066MP Remote Chime Transmitter is attached to a DA-700 Control Panel and is an option on the DA-500. It is a 315 Mhz transmitter with ASK/OOK encoded signal.
It is activated by a relay closure on a Drive-Alert, or by pushing the button on the case. It requires 15-30 volts DC on the RED and BLACK wires. The WHITE wire when pulled
to ground will activate the transmitter.
Frequency:
315 Mhz Crystal Controlled
Power:
.002 WATTS
Power Input:
15-30 Volts DC at .025 AMPS
Weight:
9 Ounces
Antenna:
1/8 Wave Quasi-Loop, -2 DBI Gain
Duty Cycle:
50% Encoder Duty Cycle at 1 Mhz
On Time:
Normally 1 Second of Transmit Time
14
Supplemental Specifications
Содержание Drive-Alert DA-700
Страница 19: ...NOTES...
Страница 20: ......
