Mier Drive-Alert DA-700, Инструкция по эксплуатации

Страница: 6 / 20

If occasional false alarms occur, or you are not detecting some vehicles, you can try re-locating the Sensor, or you can reduce the Sensor
Sensitivity. There is a small blue sensitivity pot on the electrical board. Maximum sensitivity adjustment is clockwise and minimum
is counter-clockwise (note arrow direction). Reducing sensitivity would reduce detection of road traffic, but would also reduce the
detection sensitivity in the driveway. See photo ST-A below.
The Transmitter Address Code Switches must be set to match those inside the Control Panel/Receiver. These switches are preset at the
factory for code 000 (no jumpers). Only change them if the Control Panel/Reciever code is also changed. Example: of when two neigh-
bors, living right next to each other, both have Drive-Alerts, one neighbor should switch codes so both their Drive-Alerts remain exclu-
sive to their own driveway. See photo ST-B below and CP-B on next page.
The Transmitter Zone Code Switches are preset at the factory for code 000 (no jumpers) for just one Zone/driveway/area to monitor. If
more than one Zone is to be monitored, place jumpers on the Zone Pins on the electrical board in the black box to active them, AND pull
the jumper off of the JP3 Jumper Pin inside the white DA-700 or DA-100 Control Panel. The Drive-Alert will give a different Chime tone
for each Zone monitored. See photo ST-C below and CP-C on the next page.
This photo of the Transmitter board inside the black box shows where to place the batteries, turn it On, see the Valid Transmit light,
change the Detection Sensitivity (if needed), change Addressing (if needed), set for Zoning (if needed).
Sensitivity
Adjustment
Standard Address pre-set code
is (000) no jumpers
Example of changing the
Address code by placing a
jumper over a set of pins
PCB Version ID
Wires to sensor,
Black and Red
Production Date
Standard Zone pre-set code is
(000) no jumpers
Example of changing to Zon-
ing Mode by placing a jumper
over a set of pins
On/Off Switch
Valid Transmit LED
Antenna Wire, Blue
At the base of a pole 3-foot high for Under landscape Under a DA-ROCK1 DA-611TO
greater range next to the drive fake rock next to the transmitter box
drive 4 foot high in a tree
for greater range
Note: DO NOT
mount a DA-610
on a tree.
Sensor/Transmitter Installation Examples
Battery Compartment for
two AA batteries
6
Wireless Drive-Alert Sensor/Transmitter Installation Guide
ST-A
ST-B
ST-C