Mier Drive-Alert DA-700, Инструкция по эксплуатации

Страница: 13 / 20

The DA-660 Reception Booster Antenna
is perfect when monitoring remote buildings or equipment:
This antenna is used to increase the standard reception distance of 1000-feet, to up to 3/4-mile from the Sensor/Transmitter to the
Control Panel/Receiver. Simply unscrew the standard antenna on the DA-700 Control Panel or DA-100 Control Panel and 75ohm coaxial
cable, RG6, to the F Connectors on the Control Panel and the DA-660 Reception Booster Antenna.
* 34” Long, 13” Wide, 1” High and weighs approximately 1 pound
* Frequency = 433.92 mHz
* Impedance = 75 Ohms
* Gain = 10.6 dB
* Type = 7 Element Yagi
The DA-REPEATER is perfect for providing additional alerts in remote buildings
This Drive-Alert Signal Repeater can an be attached to any DA-700 or DA-500 Drive-Alert Control Panel/Receiver. It will
repeat the alert signal to other wireless Control Panel/Receivers (DA-100CP, DA-700CP,) up to an additonal 1000 feet away, or another 3/4-
mile if DA-660s are used with them. If a site has multiple buildings and/or locations where an alert is desired, add a DA-REPEATER to a
DA-700 Control Panel/Receiver, and then add DA-100CP Chimes with Volume Control (shown below) in those other buildings.
The DA-100CP Long Distance Remote Chime for adding chimes to remote buildings:
The DA-100CP is actually a self-contained Control Panel/Receiver on its own, and receives a signal from up to 1000-feet
of any of Mier’s wireless Sensor/Transmitters, OR a DA-REPEATER (shown above), and provides a pleasant tone as an
alert. It also includes volume control.
The DA-611TO and DA-612TO Sensor/Transmitters increase transmission distance:
The Sensor(s) is/are outside the Transmitter Box, and attached to the Transmitter by a 50-foot cable (cable lengths up to 1000 feet are
available). This allows the sensor to be buried under or next to the driveway or area to be monitored, and the transmitter box to be
hidden up to 50 feet away and 4 feet above ground for an increased transmitting range. The sensor should be buried 6-12 inches below
ground and the cable 6 inches below ground. Mier HIGHLY RECOMMENDS burying the cable in 1/2-inch PVC pipe to protect it. Try the
Sensor and Transmitter above ground for a week, before burying the Sensor, to assure conditions and product operate satisfactorily.
Note: installation instructions come with these Sensor/Transmitters when ordered, or are available for download on our website.
DA-611TO DA-612TO
Please contact our Tech Support Team and we will be happy to “Google™earth” your installation site, and provide you with
information on the products needed, and locations for each piece to meet your installation/application goals.
Don’t forget to check out our website for cut-sheets, installation manuals, installation examples, and information on more products!
13
Four Options for Long Range Drive-Alert Installations
800-473-0213 ~ info@mierproducts.com ~ www.mierproducts.com