Miele T 980x, Техническая информация

Страница: 6 / 67

Technical Information
6
T 980x/T 982x
A Warning and Safety Instructions
1 General Information
Danger!
ƒ
Danger of high voltages when working on small components.
ƒ
In a single-board control, as in this appliance's electronic (EPWL 3xx),
there is no structural galvanic potential disconnection to the power supply.
Therefore, be careful when working on small components, as they may
be carrying voltage if the dryer is not disconnected completely from its
power supply.
ƒ
Components with sharp edges may stick out. Wear protective gloves and
goggles and use edge shields to prevent cuts by sharp-edged components.
Note:
ƒ
All repairs should be performed by a trained technician in strict
accordance with national, state and local codes. Any repairs or
maintenance performed by unqualified personnel could be dangerous.
When servicing, modifying, testing or maintaining appliances, all
applicable laws, regulations and accident prevention guidelines must be
observed.
ƒ
After work has been completed, a visual as well as an operational check
should always be performed.
ƒ
After work has been completed, do a touch current measurement on
machines with a ground connection on all accessible conductive parts
that are not grounded.
ƒ
Before starting any service work, disconnect the dryer from its power
source. Even with the appliance switched off, voltage may exist on some
components.
2 Gas Dryers
Warning!
ƒ
Before starting any service or repair work, it is essential to disconnect the
dryer from its gas supply.
ƒ
Service work may only be performed by a technician trained in gas
technology, and in keeping with all relevant safety standards.
ƒ
Prior to the start of service work, check all gas lines and components to
make sure that they are sealed.
ƒ
If there is a gas odor, shut the gas tap. Avoid sparks or any fire source,
and air out all rooms.