Miele T 980x, Техническая информация

Страница: 43 / 67

Technical Information
43
T 980x/T 982x
4.2 Motor Replacement
1. Disconnect the machine from the power supply.
2. Remove the dryer lid; refer to Section 010-4.1.
3. Remove the fascia, the electronic, and the electronic's support panel; refer to
Section 090-4.4.
4. Remove the front panel; refer to Section 010-4.2.
5. Remove the right side panel; refer to Section 010-4.3.
6. Unhook the spring from the intermediate drive notch (located directly below the
drum belt).
7. Release the drum belt.
8. Prop up the front of the drum to reduce any strain on the rear bearing.
9. Remove the air shield; see Section 050-4.1.
10. Remove the fan impeller. See Section 040-4.1.
11. Remove the T30 screw securing the left rear of the motor bracket, and the T30
screw securing the bottom of the motor bracket. Disconnect the Molex
connection and the ground wire (use needlenose pliers, if necessary).
12. Lift the motor up and out from the right side of the machine.
13. Install the new motor. Secure the motor bracket with the two T30 screws.
Reconnect the Molex connection and the ground wire.
14. Reinstall the fan impeller.
15. Reinstall the air shield.
16. Reinstall the heater bank.
17. Reinstall the drum, the rear bearing, and the drum belt.
18. Hook the tension spring back onto the intermediate drive notch, using
needlenose pliers if necessary.
19. Reposition the drum belt and spin the drum to ensure proper installation on the
motor drive.
20. Reinstall the metal bracket in front of the air shield.
21. Reinstall the right side panel, making sure that the grounding screws are in
their proper positions.
22. Reinstall the front panel.
23. Reinstall the electronic's support panel, the electronic, and the fascia panel.
24. Reconnect the machine to the power supply and test it for correct operation.
25. Once correct operation has been verified, reinstall the lid.