Problem
Possible cause
Remedy
:
Clean the plinth
filter which is
located in front of
the heat
exchanger
appears at the
end of a
programme.
This is a reminder to
clean the fine filter in
front of the heat
exchanger unit under
running water.
– Clean the fine filters. See
"Cleaning and care".
To clear the display:
– Select
OK
.
;
Fit plinth filter
Fit the plinth filter
appears and a
programme
cannot be
started.
The fine filter is not in
place or has been
incorrectly fitted.
– Fit the fine filter.
– See "Cleaning and care".
– Switch the dryer off and then
on again.
The programme will
be cancelled if the
fine filter is removed
while the machine is in
operation.
;
Technical fault
F1
A programme cannot
be started while there
is a fault message in
the display.
– Note what is shown in the
display.
– Switch the dryer off and then
on again.
– If a programme still cannot
be started, call Miele.
Problem solving guide
46
Содержание T 8001 WP SUPERTRONIC
Страница 70: ...70 ...
Страница 71: ...71 ...
Страница 72: ...Alteration rights reserved 2112 M Nr 09 148 220 00 ...