Miele PDR 908 HP Marine, Инструкции по эксплуатации и монтажу

Страница: 11 / 108

Warning and Safety instructions
11

Faulty components must only be replaced by genuine Miele ori-
ginal spare parts. The manufacturer can only guarantee the safety of
the appliance when Miele replacement parts are used.

To ensure the correct performance of the tumble dryer and to pre-
vent the risk of faults and fire, it is important to carry out mainten-
ance on a regular basis.

In the event of a fault or for cleaning purposes, the tumble dryer
is only completely isolated from the electricity supply when:
– it is switched off at the wall socket or the plug is withdrawn, or
– it is switched off at the mains, or the mains fuse is disconnected
– the screw-out fuse is removed (in countries where this is applic-
able), or it is switched off at the isolator switch.
See “Installation - Electrical connection”.

See “Installation” and “Technical data”.

The accessibility of the plug must be always ensured, in order to
separate the tumble dryer from the mains. All electrical work should
be carried out only by a suitably qualified and competent person, in
strict accordance with national and local safety regulations.

If the appliance is hard wired, adequate provision must be made
on site to switch off all poles to disconnect the tumble dryer from the
electrical supply.

Do not block the gap between the bottom of the tumble dryer and
the floor with plinth facings, deep pile carpet etc. This would hinder a
sufficient flow of air to the dryer.

Do not install a lockable door, a sliding door or a door which is
hinged in the opposite direction to the dryer door.