Miele PDR 908 HP Marine, Инструкции по эксплуатации и монтажу

Страница: 83 / 108

Installation
*
I
N
S
T
A
L
L
A
T
I
O
N
*
83
Electrical connection
This description applies to tumble dry-
ers both with and without a mains
plug.
The following applies to tumble dryers
with a mains plug:
– This tumble dryer is supplied with a
mains cable and plug ready for con-
nection.
– The electrical socket must be easily
accessible so that the tumble dryer
can be disconnected from the electri-
city supply.

Damage caused by incorrect
supply voltage.
The data plate indicates the nominal
power consumption and the appro-
priate fuse rating.
Compare the specifications on the
data plate with those of the mains
electricity supply and make sure that
they match.
The tumble dryer may only be connec-
ted to a permanent electrical system
that conforms to the national and local
codes and regulations.
The tumble dryer should never be con-
nected by an extension cable, e.g.
power strips, to avoid the risk of fire.
If the machine is hard wired, a dual cir-
cuit breaker must be provided on-site.
When switched off there must be an all-
pole contact gap of at least 3 mm in the
isolator switch (including miniature cir-
cuit breaker, switch, fuses and relays
according to IEC/EN 60947). This con-
nection process must be performed by
a qualified electrician.
The plug connector or isolator switch
should be easily accessible at all times.

Risk of electric shock from mains
voltage.
If the tumble dryer is disconnected
from the mains, protective measures
must be taken to ensure that the
point of disconnection cannot acci-
dentally be switched on again.
Make sure the isolator is lockable or
the point of disconnection is mon-
itored at all times.
New connections, modifications to the
system, or servicing of the earthing
conductor, including determining the
correct fuse amperage, must be carried
out by a qualified electrician, as they
are familiar with the pertinent regula-
tions and the specific requirements of
the electric utility company.
The tumble dryer must not be con-
nected to devices such as timers
which would switch it off automatic-
ally.
Single phase AC 230 V – country vari-
ant 230V 25A
This device is intended for connection
to a power supply system where the
maximum value of external phase neut-
ral loop impedance Zmax of 0.38 Ohms
at the point of distributor supply con-
nection is not exceeded.
The user has to ensure that this device
is connected only to a power supply
system which fulfils the requirement
above. If in doubt, please ask your elec-
trical distributor for actual impedance
value.