During a programme, you can switch
between the following displays:
– the current temperature,
– the elapsed programme duration and
– the active wash block:
1 = Pre-wash 1
2 = Pre-wash 2
3 = Main wash 1
4 = Main wash 2
5 = Chemical disinfection *
6 = Rinse 1
7 = Rinse 2
8 = Rinse 3
9 = Rinse 4
10 = Final rinse 1
11 = Final rinse 2
13 = Drying
^
Press
ß
to switch between the
displays.
Programme sequence
indicators
The indicator light for the active
programme stage lights up during the
programme.
k
Reactivation
I
Pre-wash 1 + 2
l
Main wash 1 + 2 *
H
Rinse 1 - 4 / Final rinse 1 + 2
c
Drying
r
End of programme
(Programme parameters have
been reached)
* Rinse block 5 (normally for chemical
disinfection) can be programmed in as
an extra stage in freely programmable
Programme
A
. It is then
not
possible to
dispense chemical disinfection agents.
The programme sequence indicator
l
will light up when Rinse block 5 is
active.
At the end of a programme
The programme has ended correctly
when
r
lights up constantly in the
programme sequence display and the
6
indicator has gone out. A
0
will
appear in the middle of the display. All
the other indicators come on and go
out in sequence.
At the same time a buzzer sounds for a
maximum of 30 seconds (default
setting).
The buzzer can be changed, see
"Programmable functions".
Use the
ß
button to call up the total
running time of a programme or the
current temperature.
Immediately the programme finishes,
partially open the door of the machine
(by about 10 cm) for 10 to 15 mins.
Only then unload the machine. A good
drying result is achieved in the residual
heat, which should help to prevent the
instruments corroding.
Operation
37