Midtronics CELLTRON MAX, Инструкция по эксплуатации

Страница: 36 / 37

CELLTRON MAX
Midtronics Inc. 7000 Monroe Street Willowbrook, IL 60527 www.midtronics.com •
36
•
PRINTER STaTUS lED
When a printer fault occurs, the STATUS LED flashes. You can
identify the fault by the number of sequential flashes:
Solutions
 If the IR transmitter and receiver are not aligned, all the
data may not print. The infrared ports on the top of the
analyzer and on the printer (below the MODE button)
should be pointed directly at each other. The maximum
distance for reliable transmission between the ports is 18
inches (45 cm).
To realign, press the BACK key to cancel the print. Verify align-
ment between the analyzer and printer; then try to print
the test results again.

If the message PRINTING appears on the screen, but no
data are printing, press the BACK key to cancel the print.
Turn off the printer and charge the printer battery for at
least 15 minutes before attempting to print again. Align
the analyzer and printer IR transmitters and print again.

Make sure the printer is on. The printer shuts off after
two minutes of inactivity to conserve the battery. To turn
the printer on, briefly press the MODE button. The green
STATUS light should turn on. Make sure you are using the
Midtronics printer provided with the CELLTRON MAX . Oth-
er printers may not be compatible.

Direct sunlight interferes with infrared data transmission/
receiving. If the printer is not receiving data, remove the
printer and the CELLTRON MAX from direct sunlight. If the
printed characters are not clear or are partially missing,
recharge the battery and reprint.

Verify that a compatible communications protocol is
selected in the printer setup. IrDA Mode is compatible
with the Midtronics printer (“IRDA Physical Layer” on the
printer’s self-test printout). Refer to the printer manual for
information.

If you are unable to print after ensuring the analyzer is
functioning, the printer is on, the batteries are good, and
the IR transmitter and receiver are aligned, see the printer
manual for further instructions or call Midtronics. (See
Patents, Limited Warranty, Service.)