Middle Atlantic Products C3 1-bay, Инструкция

Страница: 27 / 38

INSTALLING THE GROMMETS (OPTIONAL, CONTINUED)
Page 27
4. Separate the tops from the grommets (G) and place
the grommets into the holes as shown. ( FIGURE AL )
5. Save the grommet tops to install as shown, if desired,
after completing the rest of the topics in this instruction
sheet and running any cabling through the grommets
as needed. ( FIGURE AM )
Grommet
Top
Trim
Ring
FIGURE AL
FIGURE AM
G
4. Install the jumper on the inline fan controller (AS)
for one of the following functions:
• Jumper on two center pins (pre-installed location)
turns the fan on at 87º F (31º C) and off at 85º F
(29º C). ( FIGURE AP )
• Jumper on two left pins, fan will remain off.
• Jumper on two right pins, fan will remain on.
FIGURE AP
Side View of Inline Fan Controller
AS
Jumper
FIGURE AN
INSTALLING THE FAN OPTION (C3-FANKIT) TO THE WOODKIT
1. Use power driver and Phillips bit to remove (4x)
pre-installed fan mounting screws (AR) from the trim
ring.
2. Place fan (AP) into fan hole (or desired fan hole for
2- and 4-bay models) on the bottom of the woodkit
(A).
NOTE
: Verify the torque on your power driver is on the
lightest setting and only increase as necessary.
3. Use the (4x) fan mounting screws (AR) to install the
fan with the cable positioned toward the back of the
woodkit as shown. (
FIGURE AN
)
NOTE
: Position
fan cable
toward back of
woodkit.
AP
AR