Middle Atlantic Products C3 1-bay, Инструкция

Страница: 9 / 38

DETERMINING FRAME HANGING HEIGHT ON WALL
Page 9
NOTE : Your credenza’s bottom clearance (beneath the lower edge of the woodkit) must be at least 1”
(25 mm) for proper air intake. (
FIGURE A
)
This means that the minimum height (to the top edge of your woodkit) of your credeanza when mounted
to the wall is:
• 25” (635 mm) for the 24” (610 mm) model.
• 33” (838 mm) for the 32” (813 mm) model.
1. Keeping the previous note in mind, select your desired height from the finished floor and use a pencil
and level to draw a horizontal line (approxiately as wide as your frame, B) on the wall at this height.
(
FIGURE A
)
2. Measure down 2½” (64 mm) and draw another horizontal line. This is your top keyhole slot (shaded)
height.
3. Where applicable, use a stud finder to locate the studs and mark their locations with vertical lines
along the top keyhole slot height line from the previous step.
INTRODUCTION
After initial unpacking and inspection of your woodkit (A), leave the kit inside the box for added wood
surface protection until required for specific assembly steps starting on page 25.
1” (25 mm)
FIGURE A
The distance from the top edge
of the woodkit to the top keyhole
slot (shaded) is 2½” (64 mm).
NOTE : The woodkit adds 1” (25 mm) to the
frame (indicated by gray dashed line).
Line From Step 1
Line From Step 2
Bottom clearance from the
lower edge of the woodkit to the
finished floor. Min: 1” (25 mm)
B