Middle Atlantic Products C3 1-bay, Инструкция

Страница: 15 / 38

Page 15
Bracket
Holes
• Use power driver or
screwdriver and a flat
head screw (S or AJ) to
secure each power
mounting clip (T or AK)
to the bracket holes on
the bottom of the frame.
( FIGURE K )
NOTE
:
• Set power strip (U or AL)
aside and only install
after woodkit is installed
on the frame. Install by
pushing strip into power
mounting clips (T or AK)
until it snaps into place.
• Use a rubber mallet and
gently tap the power
strip into the power
mounting clips, if
needed.
TIP : Remove the power strip (U
or AL) from the power mounting
clips (T or AK) by wedging a flat
head screwdriver between the
side of the power strip and
mounting clip, and gently pry
them from each other as shown.
( FIGURE L )
Screwdriver Tip
FIGURE L
U or AL
U or AL
T or AK
T or AK
S or AJ
FIGURE K
INSTALLING THE POWER STRIP INSIDE THE FRAME FOR RACK OPTIONS
NOTE :
• The power strip (U or AL), is installed using (2x) power mounting clips (T or AK), and (2x) 10-32 x 1/4”
flat head screws (S or AJ) as part of both the Slide-Out Rack (C3-TECHKIT4-SO) and
Fixed Rack (C3-TECHKIT4-ST) options. The procedure is the same when installing either option.
• Consider power receptacles on the wall and power requirements when deciding which bay (for 2- and
4-bay models) to install your power strip.
• If using power driver, verify the torque is on the lightest setting and only increase as necessary.