Microsemi Proprietary and Confidential. LX3301A/LX3302A Auto Calibration User Guide Revision 1.0
2
2
Software Installation and Validation
The following section describes how to install and validate the software for the LX3301A/LX3302A
device.
1. Connect the dongle to the computer.
2. Connect the sensor PCB to the dongle.
3. Place your target at a desired air gap.
The first three steps are shown in the following image.
Figure 1 • System Setup
4. Set up your bench system to take measurements.
5. Launch Integrated Programming and Calibration Environment (IPCE), as shown.
