Microsemi IGLOO nano Starter Kit, Руководство пользователя

Страница: 35 / 42

R e v i s i o n 3 35
B – List Of Changes
The following table lists critical changes that were made in each revision of the chapter.
Date Changes Page
Revision 3
(January 2013) The document format and website references were changed from Actel to
Microsemi; Actel is now Microsemi SoC Products Group. The
"Product Support"
information was updated.
All
Libero Integrated Design Environment (IDE) was updated to Libero System-on-Chip
(SoC) software. Multi
The jumpers in a small packet and Libero IDE DVD were removed from Table 1 •
IGLOO nano Starter Kit Contents .
4
The "Regulatory and Compliance Information" section is new (SAR 43920). 37 – 38
Revision 2
(September 2010) The AGLN250-ZVQG100 part was replaced with AGLN250V2-VQG100 throughout
the document. References to nano-Z parts were removed (SAR 27593). 3, 11,
others
The "FPGA Description: AGLN250V2-VQG100" section was revised to change
"PLLs" to "integrated PLLs." The FlashROM bits value in Table 1-2 • Features of
AGLN250V2-VQG100 was changed from 1,000 to 1,024 (SAR 27593).
11
The following figures were replaced (SAR 27593):
Figure 1-4 • AGLN250V2-VQG100 Banks 0–3 Schematic
Figure 1-5 • AGLN250V2-VQG100 JTAG Pins
Figure 1-6 • AGLN250V2-VQG100 Power and GND pins
12 , 13
The "Reset" section was revised to remove text applicable to nano-Z devices and
state that the Schmitt trigger device can be bypassed because an AGLN250 FPGA
supports additional I/O advanced features such as Schmitt trigger. A similar revision
was made to the
"Flash*Freeze Switch" section (SAR 27593).
20 , 21
The "LCPS Stackup" section was deleted. N/A