Rotary Microtome HM 355 S
MICROM International GmbH
Robert-Bosch-Str. 49
D- 69190 Walldorf
386 200 - English
3-3-5 INDICATION OF CUTTING PROCESSES
In the lower line of the display information about
the sectioning status can be seen.
•
Press the "scroll button" (fig. 11.1), to show
the various functions one after the other on
the display.
The following information on the current
sectioning position of the instrument can
alternatively be seen in the lower line of the
display :
- number of sections
- sum of section thicknesses
- remaining travel to the front end
position
•
For this, press button (fig. 11.1) until the
required information is shown on the display.
•
If no information is required in this line, press
button (fig. 11.1) until this line of the display is
blank.
3-3-5-1 SECTION COUNTER
The section counter (fig. 12.1) adds up the
number of sections produced. After each
downward movement of the specimen holder, the
number on the section counter increases by 1.
•
The counter can be reset to zero by means of
the button (fig. 11.2).
3-3-5-2 SECTION THICKNESS SUM
This value shows the sum in microns of the
sections already cut. Trimming values as well as
sectioning values are added up (fig. 13.2).
•
This value can also be reset to zero by means
of the button (fig. 11.2).
Fig. 11
Fig. 12
Fig. 13
2
FINE= 9
TRIM= 30
SUM = 0
R : ON
0
2
FINE= 9
TRIM= 30
COUNTER= 9
R : ON
0
1
1
