Micom 3f, Руководство пользователя

Страница: 34 / 164

MICOM-3F/3T/3R HF-SSB Owner’s Guide
16
Basic Operating Instructions
This chapter provides basic operating instructions for the MICOM-3: it covers issues such as turning
the radio on and off, receiving and transmitting, selecting a channel or a frequency, etc..
Note
The information needed to use MICOM-3 in the ALE mode appears in the Using
Automatic Link Establishment (ALE) section, starting on page 34.
You can use these instructions to start using your MICOM-3 radio and become familiar with its
operation. In most cases, the radio reaches you after being configured for use in your radio net.
However, if you need to make changes, see the
Programming the Radio section, starting on page 81.
Turning the Radio On and Off
➤
To turn the radio on:
Turn the ON / OFF / VOLUME knob clockwise. You may hear a click
as the radio is turned on.
The display turns on and shows SELF TEST for a few seconds.
Note If the display is too dim, adjust its brightness using
MENU > CHAN > MORE > DIM .
MICOM-3
SELF TEST
If the self-test procedure is successfully completed, the radio
automatically resumes operation in the last used mode (CH, ALE,
SCAN, or FREQ).
MICOM-3
BAND
SQ
DSP
CH 1
F 14,000.00
USB
I
SQ
Note
If automatic dimming is enabled (DIM ALT is YES), the
display may turn off after a few seconds of inactivity. To
cancel this feature, use
MENU > MORE > PROG >
RAD > PRMT > DIM to select NO for DIM ALT.
If a problem is detected during self-test, the display shows ERR and a
code number, followed by a concise description of the error (if the
description does not fit in one row, its parts alternate in the display).
The error codes are listed in Table
7 on page 125.
If the detected problem does not prevent using the radio, press EXIT
(F1) to cancel the display and continue.
MICOM-3
EXIT
ERR01
LOW
➤
To turn the radio off:
Turn the ON / OFF / VOLUME knob counterclockwise beyond the
detent. You may hear a click as the radio is turned off.
The display turns blank.