MHP JNR4DD Series, Инструкции по сборке и обслуживанию

Страница: 23 / 40

WHRG4 and THRG2 Assembly Instructions
1. With a slotted screwdriver or 1/4" wrench, remove
the rear mounting screw on the back of the left and
right burner where they meet the grill head bottom. Use
a 11/32" or adjustable wrench on the nut on the outside
of the grill head bottom (Fig. 1).
The WHRG4 and THRG2 feature 1 Infrared Burner and 2 Cast Stainless Steel Burners combined with our revolutionary SearMagic® cooking sys-
tem. This cooking combination provides one of the most versatile, reliable and intensely heated grills in the industry. Now you can cook items at a
Lower Temperature over the cast stainless steel burners cooking area, with our Flavor Master Porcelain Briquettes, while Searing over the Infrared
Zone.
SUPPLEMENTARY ASSEMBLY INSTRUCTIONS FOR COLUMN, PATIO BASE AND IN-GROUND POST
Prior to assembling your WHRG4 or THRG2 grill with
the Column, Patio Base or In-Ground Post, the fol-
lowing instructions must be followed to gain access to
the mounting holes in the grill head bottom. Assembly
of grills with the
WCP or WCN base begins on page 6
of the Owner’s Manual.
2. Under the control panel, remove the screw on the
burner where it meets the orifice. Use a 1/4" wrench or
a slotted screwdriver for this.
(Fig. 2).
Fig. 1
8-32 X 1/2"
Hex Head Slotted
Fig. 2
8-32 x 1/2"
Hex Head
Nut On Outside
of Casting
3/16" To Surface
Ceramic
Electrode
3. Once these screws are removed from the burner,
carefully lift each out of the grill. For the Column, the
right and left burners need to be removed. For the
MPB Patio Base and the MPP In-Ground Post, only the
center burner needs to be removed.
4. Be careful not to damage the igniter when removing
the burner.
5. For mounting the grill head on the Column, follow
the instructions on page 10 and 11 of the MHP Own-
er’s Manual.
6. For mounting the grill head on the MPB Deck/Patio
Base follow the instructions on page 8 of the MHP
Owner’s Manual.
7. For mounting the grill head on the MPP In-Ground
Post, follow the instructions on page 9 of the MHP
Owner’s Manual.
8. After the grill head is mounted, reinstall the burners
into the grill head bottom. Insert the venturi tube
through the opening at the front of the grill head, and
over the orifice holder. Make sure the burner venturi is
fully engaged over the orifice holder, then tighten the
venturi set screw securely.
9. Place the Briquette Grate on the shelf edge just
above the 2 Oval Cast Stainless Steel Burners. Fig. 3
10. Carefully place the 46 Porcelain Briquettes on the
grate in the pattern shown. Fig. 3
11. Place the SearMagic Cooking Grids above the
Porcelain Briquettes and Infrared Burner.
12. The Warming Rack drops onto the top edge of the
grill head bottom. (see Fig. 35 page 18)
23
CAUTION: DO NOT BREAK
CERAMIC ELECTRODE WHEN
REMOVING OR REINSTALLING
BURNERS!
Fig.3