MHP JNR4DD Series, Инструкции по сборке и обслуживанию

Страница: 11 / 40

Mountings
OPTION: For Portable Base Only:
(Fig. 12)
1. Attach the wheels by slipping the axle through the base, slide
the wheels on and secure with the axle clips. Finish by snap-
ping the hub caps on before standing unit upright. For units
with casters, place caster stem into stem opening of the port-
able base, press and snap into place. (Fig. 12A)
Step 3: Connect the Grill Head Bottom to Stainless Steel
Column
(Fig. 13)
1
.
Attach the grill head bottom to the pedestal column top with four
¼ - 20 x1 ½" Hex bolts, washers under the bolt head and Kep nuts.
Peel the remaining protective coating off the pedestal column.
When you complete the mount assembly go to the appro-
priate Grill Assembly Section and assemble the grill head.
Step 4: Attaching the Access Panel
(Fig. 14)
Note: Do not attach the front access panel until the control
panel has been attached to the grill head bottom and
the gas supply line has been properly connected and
leak tested.
1.
The front access panel attaches directly under the control
panel and hides the access opening. Lift the access panel
up behind the lip of the control panel, then slip the bottom
double edge of the access panel (upward pressure may be
needed) over the edge of the access opening.
Caution: Combustible material should never be within 18
inches of the bottom, back or sides of your MHP Gas Bar-
becue Grill.
Fig. 12A
11
Stainless Steel Column
Aluminum Column
Aluminum Reinforcing
Bar (2)
Bolt
Washer
Grill Bottom
Reinforcing
Bar
Column
Nut
Fig. 13A
Step 3: Connect the Grill Head Bottom to Aluminum
Column
(Fig. 13A)
1
.
Attach the grill head bottom to the pedestal column top with four
¼ - 20 x1 ½" Hex bolts, washers under the bolt head, reinforcing
bar and Kep nuts.