34 Instructions GD0
7.3.4
Replacing the Remote Control Battery
The operations that must be periodically performed by the user are list-
ed below.
• Use a slightly damp cloth (not wet) to clean the surface of the
devices. Do not use any substances containing alcohol, benzene,
diluents or other flammable substances. The use of these sub-
stances could damage the devices, start fires or generate elec-
tric shocks.
• Disconnect the power supply to the automation before you pro-
ceed to remove leaves and debris, to prevent anyone from acti-
vating the door
• Periodically check the system, especially cables, springs and
supports, for possible imbalance or signs of ware or damage. Do
not use the automation system if repair or adjustment is neces-
sary, in as much that a fault or an incorrectly balanced door
could cause injury
If the range of the remote control is significantly diminished and the light
emitted by the LED is feeble, the remote control battery is probably
exhausted. The remote control houses two CR2016 type lithium batter-
ies. To replace them proceed as follows:
1
Open the bottom by pulling it.
2
Insert a small pointed tool in the slit and prise the batteries out.
3
Insert the new battery, observing the polarity (the “+” symbol towards
the bottom ).
4
Close the bottom until it clicks.
The batteries contain polluting substances: do not dispose of
them together with other waste but use the methods established
by local regulations.
7.3.3
Maintenance Operations to Be Performed by the User
Figure 79
Figure 80
7.3.5
Lamp replacement
Before proceeding, disconnect GD0 from the power supply.
1
Unscrewing screw [A] and pushing button [B], open the lid.
2
Push the lamp up and rotate to remove. Insert a new 12V / 21W lamp
with BA15 socket.
Figure 81
Figure 82
A
Figure 83
B
