MGE UPS Systems Comet 100 kVA, Инструкция по установке и эксплуатации

Страница: 47 / 66

During an emergency situation, such as a fire in the
computer or electrical room, the UPS and all downstream
devices can be instantly shut down by pressing the EPO
pushbutton on the front panel of the UPS cabinet, or by
pressing the "Remote Emergency Power Off" (REPO)
optional pushbutton.
The EPO or REPO pushbuttons should not be used for
normal shutdown of the equipment.
If the EPO pushbutton has been pressed, it must be reset by
pressing it again and by pressing the "Fault Reset" key in the
diagnostics panel to allow the UPS to restart.
Forced transfer is required if bypass input is out of tolerance.
The load can be transferred from the Inverter output to the
bypass input source, or back, with a power interruption of
500 milliseconds.
CAUTION
Using the forced transfer functions will cause the load to experience a
power interruption for a minimum of 500 milliseconds. Be certain that
the load can tolerate this interruption.
3.4.5 Forced Transfers
CAUTION
Pressing the “Emergency Power Off” (EPO) pushbutton disconnects
the attached load. The EPO is to be used during emergency situations
only, where a hazard to personnel or equipment exists, such as during
a fire. DO NOT USE THE EPO TO TURN THE UPS ON OR OFF. Follow
the procedures listed in this section for turning the Inverter on and off.
86-160310-00 3 — 11 Operation
Installation and Users Manual