5 Electrical installation
Pin assignment: digital incremental encoder (RS422)
Figure 31: Pin assignment: „digital incremental encoder (RS422) [X2]“
Pin
Name
Specification
13
US
Operating voltage for incremental encoders
15
GND
Associated reference potential
14
MT+
Motor temperature sensor, normally closed contact, PTC, NTC,
KTY
3
N / U
a0
Index pulse RS422 (differential) of the digital incremental encoder
1
#N / U
a0
12
HALL_U
Phase U of the Hall sensor for commutation
10
HALL_V
Phase V of the Hall sensor for commutation
8
HALL_W
Phase W of the Hall sensor for commutation
11
A / U
a1
A track signal RS422 (differential) of the digital incremental encoder
9
#A / U
a1
7
B / U
a2
B track signal RS422 (differential) of the digital incremental encoder
5
#B / U
a2
Cable type and configuration [X2]
As only short cables are used for the motor installation variant, shielded and twisted
cables can usually be omitted. However, the cables must not exceed a maximum length
of 80 mm. For the encoder supply US and GND we recommend a minimum cross-section
of 0.25 mm², for all other cables a cross-section of 0.14 mm².
Mounting Instructions BL 4000-M and BL 4000-D
Page 57 of 95
Содержание 9200-4104-2000
