Metronic DL7 Series, Руководство по эксплуатации

Страница: 72 / 96

DL7, DL7L
72
A message regarding alarm states is sent after exceeding at least one alarm threshold
and after returning to the normal value (it is necessary to select the E-mail Notification option
in the Alarm 1 / Alarm 2 tab, more in section Channels settings ). If several alarm thresholds
have been exceeded or the value has returned to normal at several channels, the device
will send common information about these alarms. Subject of the e-mail: DL7, ALARM,
device ID, device tag.
The message regarding the totalizers values is sent in accordance with the settings in
the Cyclic report tab (it is necessary to select the E-mail Notification option in the
Σ1
/
Σ2
tab, more in section Channels settings ). Subject of the e-mail: DL7, RP, device ID, device
tag.
General tab
Enter information about the email account from which messages will be sent. Account
outgoing server (SMTP) must be enabled. The maximum number of messages sent by email
account per day should be taken into account.
E-mail: [value]
[1]
Login: [value]
[2]
Password: [value]
[3]
SMTP server: [value]
[4]
SMTP port: [value]
[5]
[1]: The full address of the email account from which messages will be sent.
[2]: The login used on the server to log into the e-mail account.
[3]: The password used on the server to log into the e-mail account.
[4]: The SMTP server address where the e-mail account is created.
[5]: The SMTP server port (without SSL) should be verified at the e-mail provider (ports
587 or 25 are used as default).
Recipients tab
Enter the e-mail addresses of message recipients into the table. The sender of the
message ( General tab) can be also the recipient of the message.
#: 1 (1, .., 5)
[1]
E-mail: [value]
[2]
[1]: Ordinal number from 1 to 5, the message can be sent to a maximum of 5 recipients.
[2]: The full e-mail address of the recipient to which the messages will be sent.
It is recommended to check the correctness of the connection configuration using the
Test connection button located below the table. Message about the connection is
displayed, color indicates the status of the connection: green
– message sent correctly to
defined recipients, yellow
– authorization error (check the correctness of entered data in the
General tab and in the Recipients tab), red
– connection error (check the Ethernet cable,
network connection and settings of the IP address, mask and gate in the Ethernet tab).
The test message sent to the entered e-mail addresses contains the model, firmware,
serial number, device ID and tag of the device. Subject of the e-mail: DL7, TEST, device ID,
device tag.