MI 3108 EurotestPV
Instrument operation
32
4.
EurotestPV
should be selected in INIT. BT DONGLES menu. Press the TEST key.
5. Wait for confirmation message and beep. Following message is displayed if dongle
was initialized properly:
EXTERNAL BT DONGLE SEARCHING OK!
Initialization procedure (Bluetooth dongle for the Metrel Powermeter):
1. Connect Bluetooth dongle A 1436 (intended to be used with the Metrel Powermeter) to
the EurotestPV instrument’s PS/2 port.
2. Switch on the EurotestPV instrument.
3. Press a RESET key on the Bluetooth dongle A 1436 for
at least 10 seconds.
4. PowerQ series should be selected in INIT. BT DONGLES menu. Press the TEST
key.
5. Wait for confirmation message and beep. Following message is displayed if dongle
was initialized properly:
EXTERNAL BT DONGLE SEARCHING OK!
6. The successfully initialized Bluetooth dongle A 1436 is now ready to be connected to
a Metrel Powermeter.
Notes:
The Bluetooth dongle A 1436 should always be initialized before first use with the
EurotestPV instrument or Metrel Powermeter.
If the dongle was initialized by another Metrel instrument it will probably not work
properly when working with the previous instrument again. Bluetooth dongle
initialization should be repeated in that case.
For more information about communication via Bluetooth refer to chapter 8.6
Communication and A 1436 manual.
4.4.8 Initial settings
In this menu the instrument settings,
measurement parameters and limits can be set to
initial (factory) values.
Figure 4.16: Initial settings
dialogue
Keys:
UP / DOWN
Selects option [YES, NO].
TEST
Restores default settings (if YES is selected).
ESC
Exits back to settings menu.
Function selector
Exits back to main menu without changes.
