8
OPERATION MANUAL
3.1 UNPACKING
1. Place the Bead Roller on to the stand.
2. Slide the Handle (12#) onto the Driving Shaft (3#) .
3. Using a Hex Key Wrench , tighten grub screw (11#) securely . Ensure that grub screw (11#)
is positioned over the flat surface on the Driving Shaft (3#) .
3.2 ASSEMBLY
This machine was carefully packaged for safe transport. When unpacking, separate all enclosed
items from packaging materials and inspect them for shipping damage. If items are damaged,
please contact your distributor.
NOTE: Save all the packaging materials until you are completely satisfied with the machine and
have resolved any issues with the distributor, or the shipping agent.
When unpacking, check to make sure that all parts shown on page 4 are included. If any parts
are missing or broken, please contact the your distributor.
3#
11#
12#
F
ig
. 3
Attaching The Roller Tension Handle
To assemble the handle to the Hafco Bead Roller
loosen the nyloc nut, (A in Fig.4) then undo and remove
the socket head set screw (B in Fig.4) so that the upper
bearing block is free to move down the shaft. Screw
the Upper Bearing Block tensioning handle into the
casting and slide the upper bearing block back so that
the end of the handle fits into the Upper Bearing Block
“T” slot. (C in Fig.4)
Screw the set screw (B in Fig.4) into the threaded hole
in the Upper Bearing Block and tighten.
While holding the socket head set screw with a hex key,
tighten the nyloc nut (A in Fig.4), then back it off half a
turn so the Upper Bearing Block can move.
F
ig
. 4
A
B
C
06/01/2020
Instructions Manual for SJ-24D (S641)
8
