MetalMaster HG3208VR, Руководство пользователя

Страница: 11 / 24

QC11Y Hydraulic Guillotine Shear
9
2
）
Press oil filling button and angle increase button meantime, adjust the
filling pressure to 14~16 MPa and keep 2~3 seconds.
3
）
Loose the angle increase button first, then loose oil filling button, knife
beam return.
4
）
Turn the switch on the penal to cutting function
D
、
Turn the hand wheel according to the plate thickness and adjust the blade
clearance
E
、
Adjust the back gauge distance according to the plate length.
F
、
After above action is finished, then Stamp the foot switch and start the cutting.
G
、
Push the red button “EMERGENCY STOP” when machine is abnormal or
when you want to stop the machine.
H
、
After the machine is tested fine under both no load operation and load operation,
then you can make the machine into formal production. If find the machine is
abnormal, you will have to correct the problems and then put into production.
5.3 Single cutting
Turn the switch on the penal to single cutting mode, then stamp the foot switch, the
knife beam moves down and starts to cut. The cutting is finished when moves to
the lower limit SQ3 or when you release the foot switch. After complete the cutting
stroke, the machine will automatically moves up until it is up to the upper limit
SQ4 . If the plate is not cut off completely, pls do not release the foot switch to
avoid the hurt of plate.
5.4 Continuous cutting
Turn the switch on the penal to Continuous cutting mode, stamp the foot switch
and press the pump start button at the same time, then loose them, The knife beam