MetalMaster HG3208VR, Руководство пользователя

Страница: 10 / 24

QC11Y Hydraulic Guillotine Shear
8
5
、
Adjustment and Operation of the Machine
5.1 Preparation before the operation
A
、
Must backout the twice fixed pads at the inner-bottom between left and right
boards, or else it will cause mechanism troubles.
B
、
Clean the oil stains of the machine surface
，
inspect all bolts are tighten.
C
、
Fill the lubrication grease .
D
、
Clean and fill the Model L-HL 46 ordinary hydraulic oil into the oil tank
。
E
、
The machine should be grounded , connect the power supply , the machine uses
415V/50HZ power.
F
、
Tighten all hydraulic pipe connecting nut.
G
、
before the delivery of the machine, the various valves have been locked
properly and tightly. Pls do not adjust the handwheel freely to avoid abnormal
action of the machine and avoid loss.
H
、
the air pressure of accumulator has been setted to 5~6 MPa before delivery,
need not to adjust unless you have special situation
5.2 Run Trial
A
、
Power on and turn the power switch to “1 ”.
B
、
Push the motor button , and start the main motor. Inspect the motor(use the
same axis with oil pump) and make sure that the motor rotation direction should
conform to the oil pump marked direction. If not conformed, pls change the input
phase . But do not change the inner connection. When conformed, start main
motor.
C
、
Because the knife beam is on the bottom dead point, pls reset it.
1
）
Turn the switch on the penal to adjust function